Poison Ivy Poison LVY Nebulizer Engineering Sample Use Evaluation

By | 2020-12-16
Poison Ivy Poison LVY Nebulizer

The packaging is relatively simple, but the texture is improved a lot compared to the previous products. The main body of the atomizer is simple in design, and the two totems on the upper and lower totems echo the name of the poison ivy atomizer. In fact, poison ivy is reposted by friends a lot because of these 2 “poison ivy”… this time the design is quite innovative

Poison Ivy Poison LVY Nebulizer

The atomizer is in the current mainstream short shape as a whole, with the Teflon drip tip on the top. I personally think that it looks better if it is black. The side air intake is very large, and the two sides are open, so the air intake should not be a problem.

Poison Ivy Poison LVY Nebulizer

Open the poison ivy cap on the top and you can see the two oil injection holes on the top. The diameter is large, which is convenient for all current oil injection bottles. The design of the core will be modified in mass production. One is that the oil guide hole is too high and cannot be fully utilized. Another aspect of the smoke oil in the oil tank is to reduce the size of the rubber ring

Poison Ivy Poison LVY Nebulizer

As you can see from the above two pictures, the oil guide hole can be closed and the operation is very simple. The upper and lower two poison ivy can be twisted in opposite directions, the resistance is moderate, and novices should find it easier to open and close here.

Poison Ivy Poison LVY Nebulizer

2 cores, one with Notch 316 stainless steel coil and one with Kanthal wire. Notch’s 0.3 resistance belongs to the big smoke type, and the other one was killed by me before I could measure the resistance. I wanted to disassemble the bottom electrode to look at the wires inside, but I accidentally pulled all the wires out. . . But the structure is very simple and reconstruction is not difficult!

Poison Ivy Poison LVY Nebulizer

Since there is a low resistance, mechanical rods can be violent as well. We are optimistic about the bottom electrode vape. The bottom electrode of the current engineering samples is absolutely convex.

The mechanical rods on the market are perfectly compatible, so there is no need to worry about the short circuit caused by the inverted bottom electrode